This water filter purifies water going to the water dispenser and sometimes the icemaker as well. This part should be replaced if it is causing reduced water flow or just replaced periodically per the...
This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
The beverage sleeve in your refrigerator fits into the beverage sleeve holder, and allows you to store and dispense canned beverages. You will need to replace the beverage sleeve if it is damaged or m...
This compressor start relay is for refrigerators. The compressor start relay attaches to the compressor and helps start the compressor motor. Safely store any food that could deteriorate while the pow...
This light switch may also be known as a refrigerator door switch or a light switch kit, and is compatible with your refrigerator. The function of the refrigerator door switch is to turn on the light ...
This is a replacement pivot block for your refrigerator. It is made of white plastic and is approximately 4 inches long and 1 inch wide. The pivot block catches and holds the door mullion cover when y...
This kickplate grille is attached to the bottom of the refrigerator.
$102.09
In Stock
Questions And Answers for GI5FSAXVY03
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Teresa
December 7, 2019
How to reset this refrigerator after disconnecting it
For model number GI5FSAXVY03
Hi Teresa, as far as I could read in the manual there is not way to reset the fridge. The recommend temperature settings are 0 for freezer and 38 fro fridge. Thank you for your question and good luck with your repair!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Brandon
August 30, 2021
Hi my name is Brandon, I have a Whirlpool fridge model # GI5FSAXVY03. The lever where you put your cup for water or ice quite working, what part do I need ? Thank you from Brandon
For model number GI5FSAXVY03
Hello Brandon, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11738681 for the Chute and Paddle assembly. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
Food is freezing in the refrigerator compartment section and the temperature on the outside of the panel is reading 40. The air damper does not have blocking it.
For model number GI5FSAXVY03
Hello Debra, Thank you for your inquiry. We have researched the model you have provided and we would recommend checking the following parts to fix your issue: the thermistor, the refrigerator evaporator fan motor with defrost thermostat, the defrost heater, and the main control board. You can test the parts with a multimeter. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. Good luck with your repair.
Pressed in the end of the filter cover, lowered it down part way. Twisted the old filter 1/4 turn and removed it. Set in the sink to drain. Inserted new filter and twisted it to lock. closed cover. Done. Total time @ 1 Minute.
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot so I did give it a shot. I ordered the parts and they were there in less time than a service tech could come out and i installed the parts and guess what for 90.00 in parts and 15 minutes in time I repaired my refrigerator. Thanks guys, It took less time to order the parts than it did to make the repair so thanks, your website rocks and is very well designed so my hat is off to you guys!
I removed the drop-down outer housing by gently prying the sides of the two pivot pins at the rear. This gave me move 'room' to grip and slightly rotate then pull the old filter forward and away from the tight suction connection. I was concerned that I would be too forceful for the plastic assemblies and would break something; deliberate motions and a steady thought process on the problem helped disengage the darned old filter!