GA5030K (Type 3) Makita Grinder - Overview

Included in part number 515616-3

This is a genuine replacement part sourced directly from the manufacturer. The retaining ring is commonly found in power tools from Makita, such as demolition hammers, grinders, and drivers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different ret...Read moreaining rings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require pliers and a wrench or screwdriver when replacing this product. This item is sold as an individual replacement part.

This part is made of metal and is available individually. A wrench may be required to replace this part if it becomes broken or stripped. The hex nut fits between the drive gear and the gear housing. This is an authentic Makita replacement part that is sourced from the original manufacturer for use with angle grinders.

This genuine OEM sourced part is made for use with Makita power tools. It is a special shoulder pin which is utilized to secure the gear housing, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. This high-quality pin is made of durable metal and is sold individually, keep in mind the o-ring is sold separately.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

It is a Genuine OEM Sourced replacement part used on Grinders and Drills. This item is made out of Metal and it is Sold Individually. This is a Standard Hardware Screw which has multiple applications based on your equipment. Please refer to diagrams to ensure proper fit. Requires a Screwdriver to tighten or loosen this Screw.

This is an original Makita replacement part. The screw is found in angle grinders. This part is made of metal, and is generally used to secure the wheel cover assembly into place. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a screwdriver when replacing this item. This part is sold individually.

The switch lever goes next to the compression spring. This is a genuine Makita replacement part for use in Angle Grinder, Plate Joiner. This item is sold individually and is made of plastic. If this part becomes broken it will need to be replaced and may require a Screwdriver during the installation.