FME600K (Type 1) DeWALT Multi-Tool - Overview

This genuine DeWalt replacement power cord is built to last, featuring a thick, rugged rubber insulation that stands up to heavy use and tough job site conditions. Designed for reliability and safety, it includes two prongs and two bare wire leads, making it compatible with a variety of tools and applications. The cord measures 10 feet in...Read more length, offering ample reach for flexible tool placement, and uses 18-gauge wiring for efficient power delivery. Whether you're replacing a damaged cord or upgrading your setup, this OEM part ensures dependable performance. Please note: this cord is sold individually and requires proper installation—refer to your tool’s manual or consult a professional if needed.

This is a genuine replacement part for Porter Cable, Black & Decker, and DeWALT multi-tools. The switch actuator is used to manually turn the power circuit on and off. This part is made of high-quality plastic. This item is sold individually.

This is a genuine Porter Cable replacement part. The wrench assembly is designed by the manufacturer for use in multi-tools. This part is made of high-quality plastic, and is placed in the spindle assembly. You may require an Allen wrench and pliers when replacing this item. This part is sold individually.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with oscillating multi-tools from Porter Cable, Black and Decker, and DeWalt. The plastic brush holder is used to support the carbon brush within the motor housing to keep the brush pressed against the armature's commutator bars. This item is sold individually, please note two brush holders may be required.

This manufacturer sourced replacement part is designed for use with oscillating multi-tools. This assembly consists of one (1) carbon brush with a lead wire and a spring attached. Over time brushes will eventually wear down and will need to be replaced. It is advised to replace both brushes at the same type. When replacing carbon brushes...Read more, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems. You would need a screwdriver to complete this job. • Remove the screws from the housing • Separate housing to gain access to armature and brushes • Remove old brush and replace it with a new one • Re-assemble and test the tool