This part is a replacement wheel assembly for your lower dishrack. The wheels on the dishrack allow it to roll in and out of the dishwasher efficiently. If one of your wheels is broken or warped, you ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Diane
February 9, 2020
I need to replace the gasket on the detergent dispenser of my dishwasher.
For model number FGHD2472PF0
Hello and thank you for writing.
You need to replace the dispenser unit PS11770680 as the gasket is not being sold individually. We hope this helps. Please contact us anytime if you require further assistance.
how to locate and replace door latch on model fghd2472pfoa frigidaire gallery dishwasher
For model number FGHD2472PF0
Hi Larry, thank you for getting in touch. The door latch is located in the control panel of your dishwasher. First, you may need to unplug the dishwasher and disconnect the water supply. Next, remove the screws securing the inner door panel to the outer door panel. Separate the door panels and set the outer door aside. Remove the door latch mounting screws to release the control panel assembly. Lift out the door latch, disconnect the wires and connect them to the new latch. We hope this information helps!
Was this helpful?
Thank you for voting!
Steven
17 days ago
Moved dishwasher from one part of house to kitchen in barn and need tabs to anchor frame to under granite counter top. Have strip with holes mounted to underside of countertop but have no tabs anchored to frame to keep the washer from tipping when door opened.
For model number FGHD2472PF0
Hi Steven, thank you for reaching out. The part that you are looking for is the mounting bracket, part number PS12705304. If you require assistance to place an order, please contact customer service!
Disconnect from power Unscrewed 4 phillips screws from top of outer door. Unscrewed 2 screws each siide of door. Lower outer door section drops away. Note wiring sequence on dispenser, then disconnect wires. Unscrew 6 screws on dispenser and lift dispenser out.
Place new dispenser in place (note orientation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw. Reconnect wires to dispenser correctly. Slide lower outer door over tabs and secure with the 4 side screws. Ensure lower door is up under control panel and secure with the 4 top screws.
Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
replacing dishrack was simply removing old and sliding new onto track. however, removing and reinstalling water dispenser blade mounted on bottom of existing rack to new rack required much more time and effort .I needed to use flat screwdriver to pry plastic clamps apart and then a pair of channel locks to release assembly from original rack. It took some effort to finally accomplish . I believe all models that use this replacement rack would have this same issue with the dispenser blade and instructions for re-installation should accompany the new rack or better yet, new blade should be included on rack for those not familiar with using tools.