This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and ...
The drain pump ejects the water from the dishwasher.
$137.48
In Stock
Questions And Answers for FFID2426TS2A
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
DAN
May 4, 2023
I WAS HOP[ING YOU COULD TELL ME HOW OLD DISHWASHER IS NEEDS REPAIR WASHING CLEAN SUNITIZED LIGHTS STAY ON AND WONT START
For model number FFID2426TS2A
Hello Dan, thank you for reaching out. When the washing, cleaning, and sanitizing lights all flash simultaneously, it can be an indicator that the flood switch has been activated. You will find that the emergency pan has suds or water in it. Typically, this is caused by overflow from suds or an incorrect drain hose setup. The drain hose should be placed as high as possible to prevent the sink from backing up into the dishwasher and regular dish soap residue from entering the dishwasher. If you use the wrong kind of detergent, it will cause excessive suds to overflow into the pan. You can try using a wet or dry vacuum to drain the pan. Otherwise, you may have to maneuver the dishwasher around and tip it back to drain the pan.
Was this helpful?
Thank you for voting!
Nicky
February 3, 2024
Why 3 lights are blinking?
For model number FFID2426TS2A
Hello Nicky, thank you for reaching out. According to our research, the blinking lights indicate that there is a problem with the door latch. We would recommend checking the door latch. If it is not faulty, then you may need to replace the user interface control button assembly, part number PS12585991, to fix the issue. We hope this solves your problem!
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
The hardest part was disconnecting the dishwasher. the motor is located on the bottom so after pulling it out and laying it down on the front of the machine the motor unplugs and 2 screws hold it in place.The new motor comes with "O" rings so I applied a little grease and put it back together. 2 minutes to replace motor, 15 minutes to disconnect water and electric, 15 to reconnect.