The Lower Spray Arm is used in your dishwasher to spray water and clean your dishes. If broken there will be visible damage or your dishes may no longer be cleaned properly. If your spray arm is broke...
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
8 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
George
September 20, 2022
Dishwasher doesn't drain at the end of the cycle. If you hold the start cancel button then it will pump out
For model number FFCD2413US3A
Hi George,
Thank you for your question. If your dishwasher is not draining, there are some parts that you will need to check to see which one is causing the issue. You will need to check the drain pump, the drain hose and the electronic control boards. We have included some links that you may reference on how to check these parts. Once you have determined the part you need, please feel free to call customer service. We are open 7 days a week and anyone will be happy to assist you. We look forward to hearing from you!
Hi David, thank you for contacting us. We have researched your model and found that the issue is probably with the drain pump, part number PS8689824. We hope this information helps!
My home recently experienced a power outage however ever sense my dishwasher wont turn on no lights no power no nothing. I've tested and reset the breaker and unplugged it and plugged it back in with no luck. Any suggestions on what to test or what might be wrong?
For model number FFCD2413US3A
Hi Kaden,
Thank you for your question. If your dishwasher will not start, there are some parts that you will need to check to see which one is causing the issue. You will need to check the door latch assembly, the electronic control boards and the pump and motor assembly. We have included a link from our website that you may reference on how to check these parts. Once you have determined the part you need, please call customer service. We look forward to hearing from you!
Dishwasher is not running. Cycle Fills up but wont cycle. Will drain when cycle is canceled.
For model number FFCD2413US3A
Hello William, Thank you for the question. Normally this is an indicator one of the control PCB boards is defective and will not allow the appliance to start the Wash Cycle. We hope this helps!
I have had to keep replacing the spray arm on the bottom of my dishwasher which takes like 2 seconds to do.. First you open the dishwasher and than pull the bottom basked forward and reach down and pull the spray arm up and pop the bottom of the spray arm off and put it on the new spray arm and slip it back into the dishwasher over the thing that makes it spin around.. but the tricky part is and I didn't know this and this is why my dishwasher spray arm kept falling over and melting on the heating element.. you have to turn it till it clicks in.. and your done..
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
