FC350 (Type 2) Porter Cable Nailer - Overview

This replacement nose cushion assembly is an authentic item that is designed for use with Porter Cable nailers. It is attached to end of the safety element to prevent the material from getting marred or dented by the pushing lever. It is recommended to have a few extra on hand as they do have a tendency to crack or simply get lost. This part is made from durable plastic material and it is sold individually.

This is an authentic manufacturer sourced replacement part designed for use with Porter Cable nailers. It helps to provide an air tight seal between the driver and the cylinder. It is made from high quality rubber material and it is sold individually. Please note o-rings and seal over time tend to deteriorate and crack allowing for air le...Read moreaks, keep an eye on your tools performance and replace these components to maintain peak performance.

This is an authentic OEM sourced component which is specially designed for Porter Cable staplers and nailers. It is an identical replacement for a missing or faulty rolled pin that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardw...Read moreare. Keep in mind this high-quality item is made of durable metal and is sold individually.

It is a genuine manufacturer-sourced item that is supplied by the original equipment manufacturer for use with Porter Cable nailers. This is an identical replacement for a missing or a faulty compression spring that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location an...Read mored application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This unthreaded trigger valve assembly is a genuine OEM assembly used in nailers. It includes the trigger valve, 1 rubber washer, and 3 roll pins. The trigger valve controls the flow of air in the tool which drives the piston and creates the nailing action. If the valve becomes stuck, the seals wear down, or the trigger breaks the nailer ...Read morewill leak air, struggle to fire, or not fire at all. Begin the repair by switching off the tool and using a push pin to remove the trigger. Remove the roll pins that secure the trigger valve and pull the trigger valve out of the housing. Insert the new valve into the housing, install the pins to hold it in place, and secure the stay pin with the washer.