This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
$47.19
In Stock
Order within the next 12 hrs and your part ships today!
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, o...
$8.76
In Stock
Order within the next 12 hrs and your part ships today!
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and ...
$41.19
In Stock
Order within the next 12 hrs and your part ships today!
This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishw...
$103.29
In Stock
Order within the next 12 hrs and your part ships today!
This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete i...
$9.27
In Stock
Order within the next 12 hrs and your part ships today!
This filter is for dishwashers.
The filter removes food particles and debris from the water to prevent the drain from clogging.
Follow the instructions in the manual when installing this part.
$32.03
In Stock
Order within the next 12 hrs and your part ships today!
Questions And Answers for FBD2400KB11B
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim
December 27, 2019
Washer goes through cycles filling and emptying, but during the wash and rinse there is insufficient pressure to spin the arm and splash wash the top tray, since it empties fine it seems the pump is ok. Does something break under the cover part # 10 or can something be clogging the water path to the arm?
For model number FBD2400KB11B
Hello Jim,
Thank you for your question. It is most likely something clogging that is causing the arm to neither spin or spray pressurized water, the clogging is either in the pump itself, or the filter and filter base is clogged. We suggest checking those parts for any blockage before replacing any parts. We hope this helps!
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
Over Thanksgiving, the spray arm in my dishwasher apparently popped off and was partially melted. I remounted it inside the dishwasher, but the new hole was on the side of the arm. I think this resulted in water being sprayed directly against the door and not up through the top holes. It flooded my kitchen floor.
The spray arm pops on and off with plastic tabs (?) at the base. You can lightly pry with a butter knife or simply wiggle it off. The new one popped right on. Easiest repair EVER.