This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.
This is the door gasket for your freezer. It is white in color and made of rubber. The door gasket covers the circumference of the freezer door and creates a seal. If the gasket is loose or worn out, ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ingrid
December 22, 2022
ICE DEVELOPS ON BOTTOM OF FREEZER - AND OCCASIONALLY I NOTICE THERE IS A PUDDLE ON THE FLOOR, SO I THINK THERE IS A CLOG OF SOME SORT OR TOO LONG A DEFROST PERIOD. IN THE PAST I HAVE UNPLUGGED AND DE-ICED BUT THIS ONLY SEEMS TO RE-OCCUR
For model number F82U14F3W2
Hello Ingrid, thank you for contacting us. The most probable cause of the issue is a clogged defrost drain tube. If you are noticing unwanted changes in defrost cycle times, we would recommend checking the defrost timer, part number PS12585793. Also, check the door gasket, part number PS11770645, and make sure it is not damaged and no warm air is leaking into the freezer. Customer service is available 7 days a week if you require assistance placing an order. Thanks again for reaching out!
I accidently threw away both freezer keys to our upright Gibson and G.E. Freezers!!!! I had no luck finding replacements locally, so I got on the internet and came across PartSelect.com. I called them on the telephone; and after giving the model numbers of my freezers, the keys were on their way!! I received the keys very quickly and both worked perfectly. I would highly recommend Partselect.com. Charlotte M. Bishop
its best to use power screw driver lot of screws .took out all screws took off door took out side to remove ice from door. just used water to melt ice. took off old gasket and put on new gasket. put door in place and started screws in four coners do not tighten screws at this point.put in rest of screws. work arondclock wise making sure gasket is seated while tighing screws. check gasket for flatness you may have to use hair dryer on gasket to make it flat.
After silencing the alarm, it seemed to be running as normal without any unusual noises, but food was starting to thaw from the top shelf on down and condensation was dripping from the roof. We were able to place most of the food in 2 large ice chests and then the rest in the freezer compartments of 2 fridges we have in the house. I then turned down the temp dial to the coldest setting and let it run for an hour or so; no change.
After researching on the internet, it sounded like our symptoms could be pointing to a defrost timer issue. I pulled the freezer away from the wall, located the timer and used a large screwdriver to slowly advance it. While doing this, at one point I could hear the compressor kick in. I pushed the quick freeze button and let it run for a while. When I checked it in a few hours, the alarm light had gone out and water that I had placed inside was frozen. We took a chance and put the food we placed in the ice chests back in the freezer. Everything was fine several hours later.
I ordered a new defrost timer, it arrived in a couple of days, and replaced the old one with it in a matter of minutes by disconnecting the wire harness from the old timer, removing the 2 screws holding it onto the bracket, screwing the new timer to the bracket, reconnecting the wires harness, and done. It's been a week or so and no problems.