The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the door latch is open or c...
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Claudio
January 9, 2020
How to tight the microwave handle when it is loose?
For model number EW30SO60QSB
Hello Claudio, Thank you for the question. You will need to remove the inner door panel to access the screws that hold the handle in place. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Kelly
28 days ago
The control panel has come loose on right side when facing microwave. What part is needed to fix this?
For model number EW30SO60QSB
Hello Kelly, thank you for contacting us. According to our research, we would recommend tightening the screws. If the screws are fine, then you may need to replace the control panel. The control panel does not come separately. It comes in an assembly. The touch control assembly for your model is part number PS11757905. If you need help placing an order, customer service is open 7 days a week!
I don’t know how to remove the door and fix the left loosen the hinge.
For model number EW30SO60QSB
Hi Randy, thank you for reaching out. We have found the instructions to remove the door. These instructions may not be of the same model but will help you in removal. To remove the door, you may need to open the oven door. There are some catches on the sides that you need to press down on both sides. Once you have done that, bring the door back up and you will be able to lift out. Tight the left hinge which is loose using the screwdriver, and follow the same procedure backward to complete the installation. We hope this information helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up.
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a 12 volt battery and it was bad. Ordered a new one from Part select and got it fast . Works great .
After unplugging the unit remove the control face buy removing the screws. All three door switchs are on a bracket on the left. Remove the two screws holding the bracket in place and pull out. Disconnect the wires from the three switches and test each switch indivually to determine the bad one. I used a multimeter set on ohms.Replace the bad switch with the new one and replace all the wires. Reassemble the unit and you are good to go.