Restore visibility inside or beneath a compatible cooking appliance with this low-voltage halogen replacement bulb. Rated at 12 volts and 20 watts, it features a G4 two-pin base that fits into the app...
An oven that suddenly stops heating may have an open high-limit switch. This safety device monitors heat near key electrical parts and interrupts power if the temperature reaches its set limit. Its 22...
This metal oven rack provides a stable, level surface for bakeware and cookware inside select 30-inch ranges and wall ovens. It can replace a rack that is bent, warped, rusted, damaged, or missing. In...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Larry
December 5, 2024
the oven goes above the set temp after about half hour and goes into error code U20 are they a high temp switch or probe I can change?
For model number EORD230SCH
Hi Larry,
Thank you for your question. If the oven is not heating correctly, the issue may be with the oven temperature sensor. The oven temperature sensor monitors the oven temperature and signals the electronic control board to turn the elements on and off. Before removing this part from the oven and testing it for continuity with a multimeter on the Rx1 setting, unplug the oven from the electrical outlet. This test needs to be done with the sensor at room temperature to produce accurate results. The reading should be between 1080 and 1100 ohms. If you get any other reading, you need a replacement temperature sensor. If the sensor is fine, a relay on the electronic control board is bad and it will need to be replaced. We hope this helps with the repair!
Purchased a screw extractor set from the local Ace Hardware (SpeedOut). Be sure and carefully follow the screw extractor instructions as written (counterclockwise turn). Removed old screws and replaced them with new screws supplied by PartSelect.
