This white silverware basket has seven utensil sections. It also has a convenient carrying handle so that you can quickly and easily remove this basket from your D&M design Frigidaire/WCI brand dishwasher.
This rack roller is meant for usage with the lower rack of your dishwasher. It is white and just over an inch in diameter. The support for this roller is available separately. Use this roller with you...
$42.94
Special Order
Questions And Answers for DWF600EM1
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
I looked under and found that 2 brass nuts that secured the heater element through the base housing of the dishwasher has split down each side of the nut and no longer was tight enough to keep water from leaking around either end of the heater element. I powered down the dishwasher at the circuit breaker and then reached under the dishwasher and pulled away the 2 wires that were attached to each side of the heater element. I removed the two nuts and replaced them with the parts I ordered from partselect.com. I then put the appropriate wires back at the end of the heater element and ran the dishwasher to check for leaks. No leaks... it was fixed.
Removed lower trim covers (2 Phillips screws) disconnected power supply at breaker box. Removed wire from heating element, removed (broken) brass nut, unclipped heating element and removed. Removed flat washers and replaced with new grommets. Kind of tricky getting them in there. Also had to lube them with silicone to get the element back through. Installed new brass nuts and installed wire connectors. Reset breaker and started diswasher to verify repair. No leaks, working just fine, reinstalled lower trim covers
First I removed the old seal and comparied it with the new one and they were the same. Then my wife put the new seal on. I helped her on the corners, very little. She did a very good job and it does not leak now.