DW442 (Type 1) DeWALT Angle Grinder - Overview

This is an Original Manufacturer Sourced replacement Side Handle used on certain Angle Grinders and Sanders/Polishers. This part consists of a Metal Shaft and a Plastic Body. Some Power Tools are equipped with a side handle, which helps you to better control the tool while it is in operation, especially when performing heavy grinding or c...Read moreutting. To replace simply screw in the new handle into the slot in the body of the tool.

This genuine OEM replacement part is crafted from durable metal and designed to fit a wide range of power tools, making it a versatile solution for various repair needs. Whether you're replacing a worn-out component or upgrading your tool's performance, this part ensures reliable functionality. Please note that it is sold individually, so...Read more be sure to check your tool’s requirements before ordering. Installation is straightforward but requires a Torx screwdriver to properly tighten or loosen the screw. Always refer to your tool’s manual for specific installation guidance to ensure a secure fit.

This is a specially designed replacement terminal made for use with a variety of power tools. The purpose of a terminal is to allow user to easily connect a wire. One end of a terminal will allow to secure the wire, while the other end has an opening allowing user to secure it with a screw. Because this terminal is made out of conductive ...Read moremetal it will transfer the electricity through itself. Please note it is sold individually.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is an original replacement part manufactured for use with electric power tools. The special sleeve is commonly used to provide spacing between the armature bearing and the motor housing. This sleeve is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with shears, joiners, and grinders. The plastic case is used to house and protect the motor assembly and to link the gearcase. This item is available as an individual replacement part and both halves are included. A torx driver is needed to install this item.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

It is a high-quality OEM part that is specially made for Porter Cable, Black and Decker and DeWALT power tools. The receptacle is designed to safely secure and connect a wire. It is an identical replacement for a faulty or a missing part that was installed on a new unit. To ensure the correct application, refer to the appropriate diagrams...Read more of your model. Note, this high-quality receptacle is made of durable metal and is sold individually. You will need a screwdriver to take the housing apart when replacing this component.

It is a genuine OEM sourced component which is specially designed for use with DeWALT, Black and Decker, and Porter Cable sanders. The lead is utilized to connect switch, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. It is an identical replacement for a missing o...Read morer a damaged part that was installed on a new unit. Keep in mind this high-quality rubber insulated lead assembly is sold individually.

Genuine DeWalt replacement part. rn • Standard hook and loop pad (Velcro) for use with 6" discs.rn • Pad Dimensions: 6" diameter. Includes one Pad.rn • 6 dust collection holes to keep you work surface free of debris.