DW111-35 (Type 1) DeWALT Boring Machine - Overview

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is an original replacement part manufactured for use with electric power tools. The special sleeve is commonly used to provide spacing between the armature bearing and the motor housing. This sleeve is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

The left hand screw is an original part from DeWalt. The metal screw is made for use with several drill devices, and is sold individually. The screw is designed to help connect the drill chuck. A hex key or Allen wrench is helpful for the installation.

This is an authentic Black & Decker replacement part. The terminal is designed by the manufacturer for use in drills, screwdrivers, and shears. This part is made of metal, and is used to create an electrical connection within the machine. You may require a screwdriver or Allen wrench and pliers when replacing this part. This item is sold individually. Included in part number 450562-00

This holder is sourced from the original manufacturer for use in hammer drills. It is yellow in color, and measures 7 inches in length. The holder is responsible for holding the chuck key when it is not in use. The holder fits onto the body of the drill and ensures that the chuck key is easily accessible and safely stored. Replace the hol...Read moreder if it is lost, damaged, or unable to hold the key. The holder and chuck key are sold separately.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces frictio...Read moren. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement. Included in part number 605511-00

This part is an OEM from DeWALT, Black & Decker, and Porter Cable for use in drills, sanders, and saws. The plastite screw attaches to the gear case. A torx screwdriver will be necessary during the installation of this part. It will require replacing if it becomes broken or stripped. Keep in mind this high-quality part is made of metal and is priced individually.

This is an authentic manufacturer sourced replacement part designed for use with drills. This chuck key tightens and loosens the jaws of the chuck. This item is made out of metal and it is sold individually.