DW105-35 (Type 1) DeWALT Boring Machine - Overview

Included in part number 143835-02

This is a genuine replacement part sourced from the original manufacturer for use with electric drills. The special level is used as an indicator to aid the operator with drilling even level holes. This level is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

This holder is sourced from the original manufacturer for use in hammer drills. It is yellow in color, and measures 7 inches in length. The holder is responsible for holding the chuck key when it is not in use. The holder fits onto the body of the drill and ensures that the chuck key is easily accessible and safely stored. Replace the hol...Read moreder if it is lost, damaged, or unable to hold the key. The holder and chuck key are sold separately.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces frictio...Read moren. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement. Included in part number 605511-00

This replacement screw is a high-quality component which is supplied by the original equipment manufacturer for use with Black and Decker, Porter Cable and DeWalt power tools. It is a standard hardware which has multiple applications depending on the model of your equipment, please make sure to check appropriate diagrams of your model for...Read more the correct location and use of this item. This high-quality metal screw is sold individually.

This is an authentic manufacturer sourced replacement part designed for use with a variety of drills. This chuck key is specially designed to tighten and loosen the jaws of a drill chuck. It is made out of metal and it is sold individually.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This is an original part sourced directly from DeWalt. This grease was designed for use with the equipment listed below and helps to lubricate the system. This extends the life of the tool and protects parts from usual wear by allowing for easy movement. This item is sold individually.