DMO24S Dacor Microwave - Overview
Sections of the DMO24S
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
SVC-OPEN LEVER;86824,PMOR3021B
PartSelect #: PS17645012
Manufacturer #: DE81-10108A
This is an open lever for a microwave. It allows the microwave door to open when prompted. When you push on your door latch lever, it contacts the door latch assembly and releases the hooks that lock ...
No Longer Available
SVC-LATCH HEAD;86785,PMOR3021B
PartSelect #: PS17645011
Manufacturer #: DE81-10099A
No Longer Available
Belt Drive Motor Kit with Capacitor
PartSelect #: PS334458
Manufacturer #: 285222
This two-speed motor performs 1725 revolutions per minute in one speed, and 1140 revolutions per minute in the other speed. It runs at 1/2 horsepower and carries 115 volts.
No Longer Available
SVC-HIGH VOLTAGE CAPACITOR;869
PartSelect #: PS17645627
Manufacturer #: DE81-04854A
No Longer Available
SVC-SEALER FILM;86788,DMO24B
PartSelect #: PS16632544
Manufacturer #: DE81-09925A
No Longer Available
SVC-LATCH SPRING;86786,PMOR30B
PartSelect #: PS16632390
Manufacturer #: DE81-09672A
No Longer Available
SVC-DOOR PANEL;86783,DMO24B
PartSelect #: PS16632648
Manufacturer #: DE81-10093A
No Longer Available
Common Symptoms of the DMO24S
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
It was the heat safety switch in the old drive motor
It was fairly easy a few tight spaces to reach in but all in all it was pretty straight forward
Parts Used:
-
Andrew from HATTIESBURG, MS
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washer Had A Continuous Moan And Vibration
I disconnected the drive belt from the motor and ran the motor to isolate it from the rest of the mechanisms. This was the noise. I disconnected the water lines and electrical cord,laid the machine front down. I disconnected the motor plug,removed the two bracket to body bolts and lifted the motor out to the bench. I then transferred the bracket to the new motor and reversed the procedure to install the motor. The most difficult part was raising the machine back up alone,I suggest a helper.
Parts Used:
-
Roger from Millis, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Wrench set
Was this instruction helpful to you?
Thank you for voting!