The Dryer's Lint Filter is used to collect lint during the dryer cycle as it passes through the dryer vent, in order to prevent damage to the machine. This manufacturer-approved part comes in gray, me...
$69.23
In Stock
Order within the next 10 hrs and your part ships today!
The drum roller for your dryer holds the drum in place while the drum turns on the support wheels. The drum roller is round with a bearing in the middle and measures approximately 3 inches in diameter...
$163.39
In Stock
Order within the next 10 hrs and your part ships today!
This is an authentic dryer lint filter cover sourced directly from the manufacturer. It protects the more delicate lint filter in your dryer, so that it doesn’t get damaged and lint can’t mix in with ...
$74.40
In Stock
Order within the next 10 hrs and your part ships today!
This is a replacement lint screen guide for your dryer. The lint screen guide attaches to the front bulkhead and supports the lint screen. If your lint screen will not stay in place, or if you are not...
$54.54
In Stock
Order within the next 10 hrs and your part ships today!
Order within the next 10 hrs and your part ships today!
Questions And Answers for DLEX3250W
Ask our experts a question about this model and we'll get back to you as soon as possible!
5 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Michael
August 4, 2021
Dryer stays running when you shut door
For model number DLEX3250W
Hello Michael, Thank you for your question. It does sound like you may want to check your Door Switch PartSelect Number PS3529308 as the issue, Good luck with your repair.
Dryer works but when I shut the door it keeps on running
For model number DLEX3250W
Hello Aggie, Thank you for the question. This is normally an indication the Door Switch PartSelect Number: PS3529308 is defective and may need to be replaced. The Switch can be tested for continuity. We hope this helps!
My dryer keeps running after the cycle ends. The only way to stop it is to open door and it stops so i have to stop it by leaving door open
For model number DLEX3250W
Hello Carolyn, thank you for your question. The issue could be with one of the thermostats, or the electronic board. We would recommend testing the thermostats, and if they are fine the issue would be with one of the electronic boards. I hope this helps!
Was this helpful?
Thank you for voting!
Steven
March 14, 2020
The dryer doesn’t dry on the medium heat but works on the high heat. Everything is cleaned of lint.
For model number DLEX3250W
Hello Steven, thank you for writing. There are several parts we recommend checking with a Multi Meter for continuity. Those parts are the Thermal Fuse, Dryer Thermistor, and the Sensor. I hope this helps.
Was this helpful?
Thank you for voting!
Jerry
11 days ago
Dryer is working but not well. It seems to shut off before the clothes completely dry. One of your answers said 'There are several parts we recommend checking with a Multi Meter for continuity...' any instructions or web links that you can point me to so that I can do just that?
For model number DLEX3250W
Hello Jerry, thank you for reaching out. A dryer that stops prematurely could be caused by a number of issues. But we would first recommend checking the moisture sensor, part number PS3529161, to fix the issue. We have attached a link that can help to test the components with a multimeter. Good luck with this repair!
Had to replace front drum support rollers. Removed screws underneath top in back that held bracket that keeps top in place. Slid top towards rear and lifted up. Removed 4 screws that hold plastic front panel in place (inside..2 on each corner) Unplugged front panel electric plugs to remove panel. Opened door..removed 2 screws at bottom of door opening. Removed screws on top of front panel. Unplugged door switch plug. Removed front panel. Removed right front roller with 9/16th wrench for nut. Adjustable for back of stud. Lifted up on drum to get roller out. Reversed to install. Left roller a bit harder to get to stud. Removed and installed same as right side. Did not attempt to replace rear rollers. Have them if needed but very much more involved to replace.
I actually went to mr fix it on u tube. Great instruction on how to take dryer apart. First I unplugged the dryer. I found I could reach the heating system by removing the lint tube in the back of the dryer. I put my I phone with the light on inside the back of the dryer and tested the connections to see if all were working. The thermal fuse was not working. I removed the two wires , red on top and white on the bottom. Then used a small Phillips screwdriver to remove the two mounting screws and removed the fuse. I then used a vacuum to clear any lint from the back of the dryer and inside the dryer. This took me about an hour and a half. I did it this way because I did not want to disassemble the entire dryer to get to the components. I received the fuse in 3 days and tested it. It was fine. I then put it in the dryer screwed it in place, connected the wires. Replaced the lint tube. This took about 10 minutes. Dryer is running great.
Found disassembly video and watched several times. Suspected that one of the drum wheels had seized up. Found extreme volume of lint and hair inside unit as well as a dryer sheet melted on top of heating unit. Front left drum wheel was worn down from lint and hair jamming its movement. Video made it easy, not a really complicated piece of machinery. Replaced all 4 wheels due to normal wear on other three. Wanted to be sure drum evenly balanced on all 4. Parts came quickly and were easy to install. My sister and I did this together. Would not recommend doing it alone. Took time to vac and wipe down entire unit. Now it runs so quiet we have to look to see if it is operating. Got a brand new machine out of it, saved a couple of hundred dollars in repair bills, and found 11 cents inside the machine. For your own piece of mind, if you have had your dryer for several years, you need to open it up and clean it out. Its not hard... added note, we are both in our 60's... so if we can do it so can you.... Such a feeling of accomplishment, can't buy that in a store....