DDW950B-45 General Electric Dishwasher - Overview
Diagrams for DDW950B-45
See every part. Know exactly what you need.
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Lower Rack Wheel Kit - 8 Pack
Part #WD35X21038
If your dishwasher door will not close, is noisy when operating, or the dishes are not cleaning properly, you might need to replace one or more of the wheels. Each wheel and axle are made of plastic and fit into one another so they can be clipped on to the lower dishwasher rack.
Lower Front Dishrack Wheel
Part #WD12X271
This wheel is located on the front lower rack. It includes the axle. Sold individually.
Corner Tub Baffle - Lower Right
Part #WD8X227
This baffle fits the lower right hand corner of some dishwashers. It is black and has a matching left hand lower corner baffle. It is recommended that you replace and install both left and right at the same time.
Corner Tub Baffle - Lower Left
Part #WD8X228
The left and right side baffles should be installed/replaced at the same time. Right side baffle is sold separately.
Dishwasher Rack Slide End Cap
Part #WD12X10304
The Rack Slide End Cap is a white one-inch plastic part which replaces the end cap for your dishwasher rack, preventing your rack from sliding too far. If you find the dish rack is causing the door to not close properly, it may be due to the part being worn out or damaged. All you need to complete this repair is a small flat blade screw d...Read moreriver. Simply pop out the cap with a smaller flat-blade screwdriver and snap the new one into place. If the rear cap needs to be replaced you will need to remove both front caps and slide the rack completely off for full access. It is important to note that this part is sold individually, and more than one may be required, depending on your repair. An inexpensive part, it can be a good idea to purchase several at a time to have on-hand when needed.
Read less
Push On Nut
Part #WR2X7054
This push on nut is for your dishwasher or refrigerator. As the name suggests, it pushes into place, rather than being screwed in. It is approximately half an inch in diameter and is made of stainless steel.
Rinse Aid Fill Cap
Part #WD12X10284
This part helps keep the rinse aid the dispenser until its needed.
Upper Spray Arm Water Supply Hose
Part #WD24X214
This is the replacement upper spray arm water supply hose for dishwasher. It is made of white plastic and has a connector piece on each end. This hose supplies water to the upper spray arm, so it can be sprayed onto your dishes when the dishwasher is running. The main reason to replace the supply hose is if it is cracked and leaking, and ...Read morethe spray arm is not getting enough water. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.
Read less
Common Symptoms of the DDW950B-45
How this model fails, and the parts that fix it.
Leaking
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Watch our pros, then fix it yourself.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!
View More