DCN681D1R (Type 1) DeWALT Nailer - Overview
Sections of the DCN681D1R
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
NO MAR TIP, PZL
PartSelect #: PS17017009
Manufacturer #: N569446
This no-mar tip is a rubber accessory designed to attach to the nose of a nailer, helping to protect work surfaces from dents, scratches, or other damage during use. Made from hard yet slightly flexib...
$7.44
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Broken magazine end cap prevents magazine from latching closed
1. Use belt clip on staple gun to hold in place on workbench.
2. Use a hammer with a punch or small screwdriver to hit the two pins holding the end cap to the magazine. Repeat ad nauseum with as much force as you can muster until both pins come out and the broken end cap can be removed.
3. Align new end cap on magazine and use same procedure to drive pins. Exercise caution with the shorter of the two pins. If not perfectly aligned, the plastic tabs on the end cap can easily break off.
2. Use a hammer with a punch or small screwdriver to hit the two pins holding the end cap to the magazine. Repeat ad nauseum with as much force as you can muster until both pins come out and the broken end cap can be removed.
3. Align new end cap on magazine and use same procedure to drive pins. Exercise caution with the shorter of the two pins. If not perfectly aligned, the plastic tabs on the end cap can easily break off.
Parts Used:
-
Matthew from Morton Grove, IL
-
Difficulty Level:Difficult
-
Total Repair Time:30 - 60 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!