D28143-AR (2) DeWALT Grinder - Overview

An authentic OEM sourced replacement hardware that is specially produced for Dewalt grinders. It is generally used to secure the gear case cover. Please note one durable metal Torx screw is included per order.

The bearing cup is an OEM sourced part that is used with Craftsman angle grinders. This is not an aftermarket imitation part. This item is used to secure the bearing on the commutator side of the armature within the motor housing assembly. This item is available as an individual replacement part.

This is a genuine Dewalt replacement part, it is sold individually. The 648743-00 acts as brush holder for the models listed below. The 636760-00 Brush Spring is positioned behind this part to keep the brush in contact with the armature. There are two of these parts in the tool.

If your DeWalt tool is running rough, losing power, or not starting at all, it might be time to replace the carbon brushes. These small but essential parts help power the motor and are one of the most commonly replaced components in power tools. This genuine DeWalt replacement brush is sold individually, and most tools will need two brush...Read morees—so it’s best to replace both at the same time, even if only one looks worn. Worn brushes can cause your tool to run intermittently, lose electric braking, or stop working altogether. You might notice signs like cracks, burn marks, or the brush being worn down near the wire. Replacing them is a simple fix that can bring your tool back to life. While you're at it, take a moment to inspect the motor’s armature for any damage. Always check your tool’s manual to make sure this part fits your model.

It is a genuine DeWALT component which is specially designed for use with grinders. The pinion is an important part of the unit which helps to drive the shaft. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement to ensure your tool functions properly. One durable metal pinion gear is included. Refer ...Read moreto the appropriate diagrams for your model for the exact location and the correct application. You will need a screwdriver to take the housing apart in order to perform this repair.

This item is an authentic DeWalt replacement part that has been OEM sourced. The separator fan is intended to be used with angle grinders. The plastic fan fits into the rear baffle and is used to move air through the motor case. This item is available as an individual replacement part.

This replacement wrench is a genuine high quality item that is specially designed for Dewalt grinders. This spanner wrench allows user to secure or remove the flange nut which holds the grinding disk. This wrench is made out of durable metal and it is sold individually.

This is a Genuine OEM Authorized replacement part used on DeWALT Power Tools. This item is made out of Metal and it is Sold Individually. This is a Standard Hardware Screw which is generally used to hold two pieces of housing together. Requires a Phillips Screwdriver to tighten or loosen this Screw.

This replacement screw is an authentic OEM sourced item, not an aftermarket equivalent. This is screw is used in a lot of different applications depending on your tool. Please check appropriate diagrams for correct use and location of this screw. This pan head screw is sold individually. You will need a torx screwdriver when working with this hardware.