D26670K (Type 1) DeWALT Trimmer - Overview

This is an OEM replacement part for DeWalt laminate trimmers and jointer plates. The cord protector protects the power cord from getting damaged. To install or replace the power cord requires no tools, simply slide the cord in place through the cord protector. This part is made of rubber and is sold individually.

This is a genuine replacement part that has been sourced to be used with laminate trimmers and circular saws from DeWalt and Porter Cable. The sealed bearing is used to reduce friction between a rotating shaft and a fixed part assembly. This bearing can have different applications based on the model of the equipment. It is recommended to ...Read morereview your model's part diagram for this part's location and usage. This item is available as an individual replacement part.

Genuine OEM Replacement Part used on some Laminate Trimmers. This part is made out of Plastic and it is Sold Individually. This part allows a router to glide smoothly on the routing surface. Please note screws used to attach this item are Sold Separately.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine OEM sourced replacement switch, not an aftermarket imitation. It is specially designed for a Dewalt laminate trimmer. It is the part of the tool that allows user to turn the tool on and off. Mechanical switches over time will begin to fail requiring replacement. Please note, this plastic item is sold individually. To re...Read moreplace this switch you would need a screwdriver. • Remove the end cap • Disconnect wires from the old switch • Remove the old switch • Place the new switch in the housing • Reassemble and test the unit