D2002M-WK (7) DeWALT Compressor - Overview

This is sold as a set that contains all the necessary parts. A set of pliers might be necessary during the installation of these items. They are made of metal and plastic and will require replacing if they break. These are genuine DeWALT parts sourced directly from the manufacturer for use in compressors.

This genuine OEM replacement kit is designed for use with select air compressors and includes essential components to restore proper function. The kit comes with a piston rod, compression ring, cylinder sleeve, and bearing—ideal for repairing worn or damaged internal parts. Please note that this kit does not include the valve plate, head ...Read moregaskets, or any other compressor components, so be sure to check your model’s requirements before beginning repairs. Installation requires basic tools: a screwdriver, hex key Allen wrench), and pliers. With these tools and a bit of care, you can perform a straightforward repair that helps extend the life and efficiency of your compressor.

This is an authentic Porter Cable replacement part manufactured for use with air compressors. This three wire cable had terminals at the end of the wires to make installation easier. The cable is sold individually.

When using an air compressor, moisture naturally builds up inside the tank as air is compressed. If this water isn’t drained regularly, it can lead to internal rust and damage over time. That’s where the drain valve comes in—it allows you to release the built-up water and keep your tank in good condition. Located at the bottom of the tank...Read more, this valve should be opened after each use to prevent corrosion and extend the life of your compressor. If you tend to leave air in the tank for long periods, water accumulation can be even more significant. This replacement drain valve features a thread size of 18 TPI and is sold individually. Regular maintenance with a working drain valve helps ensure safe and efficient compressor operation.

This is an OEM part sourced directly from the manufacturer. The belt is commonly found in Craftsman air compressors. This part is made of flexible rubber, and is used to transfer power between the piston and the pump assembly. Over time, it may become cracked and brittle, requiring replacement. You may need an Allen wrench or hex key when replacing this part. This item is sold individually.

This is a genuine replacement part manufactured for use with air compressors. The special quick connect threads into the regulator manifold and is used to link the air compressor hose. This quick connect is available as an individual replacement part, please note two may be required.

This is manufacturer approved replacement part designed for use with air compressors. This is the hose that delivers fuel from the tank to the engine. It is made out of rubber and it is sold individually. Please note fuel filter and hose clamp are sold separately.

This is an OEM replacement part used on Air Compressors. The gauge registers pressure readings and allows you to maintain needed pressure. This Gauge is Sold Individually. You would need a Wrench to secure this Gauge to the Manifold. When replacing this item make sure to unplug the air compressor and bleed out air from the tank.