D2002M-WK (5) DeWALT Compressor - Overview
Sections of the D2002M-WK
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
PUMP ASSEMBLY
PartSelect #: PS12522876
Manufacturer #: N087118SV
$195.97
In Stock
Order within the next 12 hrs and your part ships today!
POWER CORD
PartSelect #: PS12508483
Manufacturer #: N137875
This is an authentic Porter Cable replacement part manufactured for use with air compressors. This three wire cable had terminals at the end of the wires to make installation easier. The cable is sold individually.
No Longer Available
DRAIN VALVE
PartSelect #: PS12508562
Manufacturer #: N286039
When using an air compressor, moisture naturally builds up inside the tank as air is compressed. If this water isn’t drained regularly, it can lead to internal rust and damage over time. That’s where ...
$12.20
In Stock
Order within the next 12 hrs and your part ships today!
GASKET UMC
PartSelect #: PS12512459
Manufacturer #: A03865
This replacement gasket is designed to create a tight, reliable seal between the cylinder head and the body of the cylinder in select air compressors. It helps prevent air leaks and maintain consisten...
$7.44
In Stock
Order within the next 12 hrs and your part ships today!
CLAMP HOSE .250 ID
PartSelect #: PS12513333
Manufacturer #: CAC-1206-1
This replacement hose clamp is designed for use in various compressor models and serves an important role in securing hoses to specific parts of the unit. Whether you're performing maintenance or repl...
$7.44
In Stock
Order within the next 12 hrs and your part ships today!
Common Symptoms of the D2002M-WK
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Worn piston rod and sleeve
Disassemble plastic housing around compressor unit using appropriate tools. Remove the four bolts from the compressor head using a 5/16 nut driver. Carefully remove head assembly including airline. Remove bolt through rod bearing with Allen wrench.
Reassemble with new rod and piston assembly. Best to use blue locktite on bolt through rod bearing when reassembling. Make sure to torque all bolts to specs listed.
Reassemble with new rod and piston assembly. Best to use blue locktite on bolt through rod bearing when reassembling. Make sure to torque all bolts to specs listed.
Parts Used:
-
Donald from BRYAN, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
7 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The compressor was getting air
Put the seal in and it ran like a champ. No vacuum leak and it now runs again!
Parts Used:
-
Linda from CARO, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Socket set, Wrench set
3 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!