CVEX4100B20 Jenn-Air Cooktop - Instructions

First, the Sears repairman diagnosed the switch as broken, and told us that th part, if it were available, would be $150 plus labor. However, he said it was not available, so we'd need to get a new counter top stove all together. Not.

I came to Parts Select, and I found the fan control switch listed here (if you found this story, you've found the right part). In one day, I had the part in my hand...the part that Sears said didn't exist.

First, I turned off the main fuse switch controlling the stove top! Very important! Then I tried to heat up the elements to verify that the electricity was disconnected.
I removed the glass top, then the pan, then removed the side screws that hold the flange in place, the same flange thae holds the knob control area in place. Then I removed the knobs (they just pull right off). Then I removed the knob control area. A small nut holds the fan control switch in place. Remove that, then the switch is loose under the control area. There are 4 wires, but two are connected to each other, so don't panic! Swap them out for your new part, and at this point, very carefully, turn on the main electric again and verify that the switch works. It should.

Turn off the electricity again, then mount the switch up under the control area. There should be a little, bitty tab on the control switch box that fits perfectly into the metal control panel, just to the left of the hole for the stem of the control switch--proof that this switch is meant to be used on this Jenn Air Expressions model CVEX4100/4270/4370 series counter top.

Then reverse the steps to replace all the panels, knobs, pans and elements, and you can cook without smoking up your kitchen, all for thousands less than a brand, new appliance.

Oh, one more thing. The nut around the old switch cannot be used on the new switch. However, you can use a nut from a coaxial cable fitting! It is the same thread count. I used mine from an RCA In Line F Connector 4 pack...part number VH664N.

Lift off blower vent cover. Lift out old filter. Clean walls and bottom of down draft using degrease soap and warm water. Dry. Discovered my grease filter will not install diagonally as shown in unit manual. Decided to drop into downdraft and put in front of fan suction. Found this left a gap at the top of fan suction that was not covered by the filter. Cut piece of wood 1 inch thick and width and length to drop down in the downdraft and lay on bottom. Set filter on top of wood in front of the fan suction. Verified that fan suction would pull filter tight against the opening by turning fan on and off. Put vent cover back over downdraft and told wife I was done.

I removed the center vent and inserted the filter...easy as pie...I went to your website and everything was there in an easy to follow way that even I could understand, my husband was totally impressed that I took care of it on my own....silly man.....it was so easy and delivery was extremely quick....so simple....thank you for making it so!!!!

Our Jenn-Air cook top is 25 years old. One can no longer order parts for this old of model. We ordered new SS burners as well as new Burner cartridge terminal blocks for a new and current model. They work perfectly. Took 10 minutes. $ 350 dollars verses $ 2600 for a new JennAir range plus instillation. Unit looks and works great. Plan to order new switches next.

Replaced the filter which required no tools.

I looked up the part on the web site and ordered it. When it arrived, I unscrewed the control face plate and got access to the switch. The new switch did not match the old one. I called Jenn- Air parts, and they said it was the correct one. although the switch looked different. (The old one looked like it had 4 connections. After closer look, it had three connections all on one terminal.) I installed the new one and it worked. If you replace your fan switch, be careful. The new one is different than the old one, but it works fine.

I took out the side of the cooktop that did not work. I had to take off the bottom of the cooktop and checked where electricity was going and not going. Once I found the part that needed replacing, I went on the website, search for Jen-Air cooktops and model number. From the sketch on the website, I was able to order the part needed. I decided to get 2 in order to replace both parts at one time, just in case. The part arrived quickly and was easy to install. The most time I spent was taking the backside off the cooktop and cleaning it.

Shut off the power at the fuse box.
Removed the IR unit.
Removed the (4) surface unit control knobs.
Removed the 3 screws (philips) that hold the control strip in place.
Loosened the old switch with a 1/2 " wrench.
Removed the control strip,
Removed the old switch, moved the wires from the old switch to the new switch, it was a bit different, but although at first glance it looks like there are multiple connections for the blue wires, they are all interconnected, on both the old and the new switch.
Mounted the new switch in the control strip, then when testing it (no power yet) I found out I had mounted it wrongly (Off was now on top) I turned the switch, mounted the control strip and all the knobs.
Turned the power back on and everything worked as designed.
One word of caution, I used my lathe to drill out the broken stem from the original control knob (did not want to spend the $$ for a new one) if you do not have the tools to do that I suggest you buy that knob also when you order your new switch.

Just needed to replace a scratched up grill on my stove top. The black paint was scratched off and looked horrible. You site made it very easy to find what I needed and it got here in two days. If I had known it was going to be that quick and easy, I would've done it a long time ago! Thanks!

Ordered a replacement grease filter.

I merely lifted the downdraft cover and inserted the new screen as
directed. THANK YOU FOR YOUR PROMPT RESPONSE TO MY ORDER.

Just placed new filter in slot

Took the old one out, plopped the new one in.

neighbor did it. removed glass cooktop in order to access the switch. removed switch. replaced with new one. replaced glass cooktop

very easy slip in