CS30 (RY26500) Ryobi Trimmer - Overview
Sections of the CS30
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
String Head Assembly
PartSelect #: PS9865222
Manufacturer #: 000998265
Genuine OEM replacement part, This item is sold as a kit. This is the complete Stringhead Assembly for the Trimmers shown below. It is a dual line head. To install this part, slide it on the spindle o...
$78.95
Special Order
Bolt
PartSelect #: PS12635076
Manufacturer #: 660643001
Bolt,handle(1/4-20 x 1.53 in)
$5.95
Special Order
Trimmer Intake Gasket
PartSelect #: PS10022356
Manufacturer #: 901551001
Genuine OEM replacement part, this item is sold individually. The purpose of the 901551001 Intake Gasket is to create a seal between the Heat Dam and the cylinder head. Over time because of the heat i...
$5.95
Special Order
Trimmer Screw (M6 X 20 Mm)
PartSelect #: PS9989492
Manufacturer #: 660697002
It is a genuine replacement part that is supplied directly from the original equipment manufacturer for use with Homelite and Ryobi handheld trimmers and brushcutters. This is the main screw used to s...
$5.95
Special Order
Screw (m4 X 19 Mm)
PartSelect #: PS9989642
Manufacturer #: 660968001
This is a genuine manufacturer-sourced replacement screw which is specially designed for use with Homelite and Ryobi handheld lawn and garden equipment. It is a standard hardware which has multiple ap...
$5.95
Special Order
Crankcase Cover
PartSelect #: PS9987765
Manufacturer #: 638337005
This is an authentic replacement part sourced directly from the manufacturer. The crankcase cover is commonly found in yard tools from Ryobi and Homelite, such as trimmers, blowers, pruners, and edge...
$5.95
Special Order
Heat Shield
PartSelect #: PS9987793
Manufacturer #: 638442001
It is a genuine item that is supplied directly from the original equipment manufacturer for use with Ryobi and Homelite handheld lawn and garden equipment. This is an identical replacement for a missi...
$5.95
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Would not run
Replaced carburetor, fuel lines, fuel filter and spark plug all from parts select. Very small amount of carburetor adjustment. Worst part was replacing fuel lines into fuel tank. Sharpened edges and put dawn dishwashing detergent on them and pulled them through tank with needle nose pliers! Worked like a charm!! Spent only about 45 minutes.
Parts Used:
-
Herbert from SPANISH FORT, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Socket set, Wrench set
4 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
bearing set up in lower shaft.
-
Irvin from BURR OAK, MI
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
THE DRIVE SPLINE IN THE MIDDLE OF THE SHAFT WOULD NOT ENGAGE
-
JAE from MILL HALL, PA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
3 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!