CPFAC2040P (Type 3) Porter Cable Compressor - Overview
Sections of the CPFAC2040P
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Oring 2.132/2.096id
PartSelect #: PS10050740
Manufacturer #: SSG-8169
O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. rnrnThere are many cause...
No Longer Available
DRAIN VALVE
PartSelect #: PS12508562
Manufacturer #: N286039
When using an air compressor, moisture naturally builds up inside the tank as air is compressed. If this water isn’t drained regularly, it can lead to internal rust and damage over time. That’s where ...
$12.20
In Stock
CLAMP HOSE .250 ID
PartSelect #: PS12513333
Manufacturer #: CAC-1206-1
This replacement hose clamp is designed for use in various compressor models and serves an important role in securing hoses to specific parts of the unit. Whether you're performing maintenance or repl...
$7.44
In Stock
REGULATOR 3PORT P2 L
PartSelect #: PS12513335
Manufacturer #: CAC-4296-1
This replacement regulator is a high quality item that is supplied from original equipment manufacturer for use with air compressors. It allows user to adjust the pressure of the air coming from the t...
$47.02
Special Order
HEAD UMC PRESSURE RE
PartSelect #: PS12513400
Manufacturer #: D25877
It is a genuine OEM supplied part that is made for use with portable air compressors. A cylinder head sits at the top of an air compressor pump. Its purpose is to route air through the compressor and ...
No Longer Available
Common Symptoms of the CPFAC2040P
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Worn piston rod and sleeve
Disassemble plastic housing around compressor unit using appropriate tools. Remove the four bolts from the compressor head using a 5/16 nut driver. Carefully remove head assembly including airline. Remove bolt through rod bearing with Allen wrench.
Reassemble with new rod and piston assembly. Best to use blue locktite on bolt through rod bearing when reassembling. Make sure to torque all bolts to specs listed.
Reassemble with new rod and piston assembly. Best to use blue locktite on bolt through rod bearing when reassembling. Make sure to torque all bolts to specs listed.
Parts Used:
-
Donald from BRYAN, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
7 of 11 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The compressor was getting air
Put the seal in and it ran like a champ. No vacuum leak and it now runs again!
Parts Used:
-
Linda from CARO, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Socket set, Wrench set
3 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!