Models
>
CM200
CM200 Jenn-Air Cooktop - Overview
Models starting with CM200
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Cooktop Downdraft Vent Grease Filter
PartSelect #: PS11757584
Manufacturer #: WPY706012
This grease filter is sixteen and a half inches long and nine inches wide. It is made of metal and is intended for use with downdraft ranges and cooktops.
$61.73
In Stock
Screw
PartSelect #: PS12349731
Manufacturer #: W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$26.51
In Stock
Exhaust Vent Blower Wheel
PartSelect #: PS11757592
Manufacturer #: WPY707985
This exhaust vent blower wheel is almost seven inches in diameter, and just under four inches deep. It is made entirely of metal and is used with a range's venting system.
$118.15
In Stock
Motor Isolator
PartSelect #: PS11743903
Manufacturer #: WP71003558
This motor isolator is less than an inch long.
$10.38
In Stock
Screw
PartSelect #: PS11742467
Manufacturer #: WP4381696
This band screw is sold individually.
$9.87
Special Order
Glass Grease Collecting Jar
PartSelect #: PS11757591
Manufacturer #: WPY707869
This jar is a little over five inches long. It is made of glass and is used for collecting the grease drippings of gas ranges.
$58.02
Special Order
Screw
PartSelect #: PS2076840
Manufacturer #: 707407
This screw is sold individually.
$12.18
Special Order
Downdraft Motor
PartSelect #: PS2201767
Manufacturer #: Y706132
This part helps draw the steam and odors through the vent when the fan switch is activated.
$375.49
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Replace Grease Filter For Downdraft Stove Top
Lift off blower vent cover. Lift out old filter. Clean walls and bottom of down draft using degrease soap and warm water. Dry. Discovered my grease filter will not install diagonally as shown in unit manual. Decided to drop into downdraft and put in front of fan suction. Found this left a gap at the top of fan suction that was not covered by the filter. Cut piece of wood 1 inch thick and width and length to drop down in the downdraft and lay on bottom. Set filter on top of wood in front of the fan suction. Verified that fan suction would pull filter tight against the opening by turning fan on and off. Put vent cover back over downdraft and told wife I was done.
Parts Used:
-
Johnnie from Daphne, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
27 of 33 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Filter was starting to come apart from frequent cleaning.
I removed the center vent and inserted the filter...easy as pie...I went to your website and everything was there in an easy to follow way that even I could understand, my husband was totally impressed that I took care of it on my own....silly man.....it was so easy and delivery was extremely quick....so simple....thank you for making it so!!!!
Parts Used:
-
Mary H. from Appleton, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
20 of 27 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Worn grease filter
-
Louise from Birmingham, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
13 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!