This door gasket can be installed by simply pressing it into the channel around the door. This dishwasher door gasket, or door seal, allows the dishwasher door to have an airtight seal when closing th...
This silverware basket has eight sections and is all white in color. It is also made of plastic and has a built-in handle on either side so that you can quickly and easily remove it from brand dishwasher.
This water inlet valve is specially designed for those dishwashers of the vertical axis style and comes with a mounting bracket. The attaching solenoids on the valve open and close according to the de...
This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
This pump housing filter is twenty-three inches long and a little over two inches wide. This filter wraps around a dishwasher's pump housing and clips in place. It is all white in color and is made of...
$57.93
In Stock
Questions And Answers for CDU810B
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Chip
April 26, 2023
I inherited this dishwasher from the previous occupant of the house. He had ordered a new pump motor (I don't know where from) but wound up buying another dishwasher before the replacement motor arrived. He replaced the motor but never tested the repair. I reinstalled the dishwasher and turned it on. The washer started to fill with water, then it just stopped after about a minute. It has about three inches on water in the bottom, but it never completed the cycle, and it doesn't respond to the drain cycle. When I push one of the buttons there's a brief hum, then nothing. What parts should I test, and how do I test them?
For model number CDU810B
Hello Chip, Thank you for writing. If the appliance does not start the wash or drain cycle we suggest checking the Door Switch. The appliance may not start the wash or drain cycle if it thinks the door is open. We hope this helps!
Took out about 7 torx screws to remove the inner door liner. Discovered evidence of leak coming from the sop dispenser latch, and noticed the grommet had turned soft and was torn. The grommet is only about 1" square. Used nut driver to remove two screws to remove latch assembly. Slipped old grommet off and put new one on, and reattached the latch. The foam seal at the bottom of the door looked worn, so we replaced it with weatherstripping from home improvement store. The main door seal was brittle, so we replaced it too - just grab an end and pull the old one out. The new one was installed by starting at one end and we just pushed it in place. We used a nut-driver to push it in - we were afraid a screwdriver might damage it. The new door seal required us to latch the door to get it to stay closed the fist couple of days, but now it has loosened up a bit and works as expected. And NO MORE LEAKS. Cost is much less than a new unit!
I opened the end stop of the rack, replaced the roller, and put the end stop back on. I can't believe I paid the repairman the last time $125????? An he put in a regular screw that rusted and broke the roller. Took me 3 minutes! Thanks