This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the spl...
This water inlet valve is for washers.
The water inlet valve controls the water flow into the washer.
Unplug the washer and shut off the water supply before installing this part. Wear work glove...
The drain hose carries used water from the washer to your house drain.
$31.80
In Stock
Questions And Answers for CAW8350EW1
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Shamar
November 25, 2023
My washing machine will fill up with water, then makes loud noise intermittently when attempting to wash.
For model number CAW8350EW1
Hello Shamar, thank you for the question. According to our research, we would recommend checking the washer drive pulley, part number PS10057144, to fix the issue. We hope this solves your problem!
The lock lid is stuck on, locking the lid, holding the push/start for 3 seconds will not unlucky the lid
I don’t know how to open the lid. I don’t know if I would force it open which will break the lock if it will start again and run its full cycle if the lid isn’t locked
For model number CAW8350EW1
Hello Jane, Thank you for the question. You will need to open the Cabinet of the appliance to access the lock to remove it to release the Lid. We hope this helps!
Was this helpful?
Thank you for voting!
Jim
February 17, 2023
Washing machine stops before completing cycle and indicator light goes back to wash. Is this a bad control board?
For model number CAW8350EW1
Hello Jim, thank you for reaching out. Based on our research, you need to check the following parts to fix this issue: selector switch, part number PS11752020, drive motor, part number PS11757089, drive belt, part number PS11747978, and the control board, part number PS12347257. If any of these parts are found to be defective, replace them. We hope this sorts out your problem!
Well, first investigated and found loose nut on drive clutch. First take off the two screws with nut drive then cover off using a screwdriver blade to snap off the cover. Then socket ratchet to take off the nut on drive clutch. take off belt by slowly rotating the drive gear. two screws that hold the electronics to the upper drive clutch and put aside, so you can snap off the cover for drive clutch on upper part with screwdriver and off the parts come and install whole unit back as took it apart. Line up the new upper clutch so that is position as was before. (Using parts diagram helps a lot as www. partsselect.com has for you or Maytag.com.) Then put the electronic part board back on and the gear and nut. Make sure it is tight by several attempts to make sure it's snugged up good and then slowly roll belt back on the pulley and motor drive. Put your cover guard back on with two screws and done.
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.