C950524302A Craftsman Snow Blower - Overview

This lower front drive cable is designed to engage and disengage the traction system on two-stage snowblowers, allowing smooth, reliable forward and reverse movement. Built with a durable steel inner wire and protective outer conduit, it helps maintain consistent drive response in cold, demanding conditions. Ideal for replacing a stretche...Read mored, frayed, or broken cable, it restores dependable traction control and easy handling during snow-clearing operation.

This genuine OEM axle shaft pin is designed for use with Murray and Simplicity snow throwers. Made from durable metal, this part securely connects the wheel to the axle shaft, ensuring proper traction and movement during operation. To ensure compatibility, it’s recommended to consult your model’s parts diagram before ordering. This pin...Read more is sold individually and is an essential component for maintaining the structural integrity and performance of your snow thrower.

This is sold as a set that contains eight washers. These parts attach to the tank and are made out of metal. They are genuine items that are supplied by the original equipment manufacturer for use with Craftsman air compressors. During replacement, it may require a wrench to help install these parts correctly. They will require replacing if they become bent or broken.

This replacement washer is supplied by the original equipment manufacturer for use with Craftsman equipment. It helps to distribute the pressure evenly and provide a tight seal between the connected pieces. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality pack includes eight durable metal washers.

This is a genuine Ridgid replacement part, it is sold individually. The purpose of the 823572 Guide Block is to keep the the bandsaw blade as straight and vertical as possible when cutting material. There are four Guide Blocks on the bandsaw. To adjust the Guide Blocks • Two adjustments must be made. • First, the block guides must be adj...Read moreusted in the back-forward direction so that the blocks themselves are centered on the width of the blade. • The block guides must also be adjusted in the side-to-side direction. Adjust the block guides so that the blocks themselves just barely touch the bandsaw blade.