BTL063 Makita Impact Driver - Overview

This is a genuine replacement part sourced directly from the manufacturer. The retaining ring is commonly found in power tools from Makita, such as demolition hammers, grinders, and drivers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different ret...Read moreaining rings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require pliers and a wrench or screwdriver when replacing this product. This item is sold as an individual replacement part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a missing or damaged rubber pin that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This is an authentic part made by original manufacturer. This bearing is compatible with various Makita power tools. A bearing serves to separate and buffer moving parts. It also keeps the moving parts in position while still allowing them to move/turn as needed. As a high-wear part, bearings are often replaced. This item sold individually. Washers and retainers sold separately.

This is a genuine Makita replacement part, it is sold individually. It is part of the bit holder. Without this Ball the bit would not stay in the holder. It is used in a number of different tools for different reasons. But it is most popular in Cordless Impact Drivers and Corded Screw Drivers. Compatible with the tools listed below. The diameter is 3.5mm.

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.