BTL061 Makita Impact Driver - Overview

This is a genuine replacement part sourced directly from the manufacturer. The retaining ring is commonly found in power tools from Makita, such as demolition hammers, grinders, and drivers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different ret...Read moreaining rings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require pliers and a wrench or screwdriver when replacing this product. This item is sold as an individual replacement part.

This is Makitas Lithium-Ion charging system. This charger uses three controls to ensure the best possible charge: Temperature, Voltage, and Current. These controls are monitored by a chip on the battery, and analyzed by a CPU on the charger. This prolongs battery life, and keeps cordless power tools running at peak performance. There is ...Read morea forced air fan on board the charger, keeping batteries cool while re-charging. A 3.0 Ah battery will charge in less than 45 minutes.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This is a Genuine OEM Sourced replacement part designed for Makita Impact Drivers. This part is made out of Metal and it is Sold Individually. This Washer helps to provide seal for the Sleeve. When replacing this part you would need a Screwdriver and Pliers.

This is an authentic part made by original manufacturer. This bearing is compatible with various Makita power tools. A bearing serves to separate and buffer moving parts. It also keeps the moving parts in position while still allowing them to move/turn as needed. As a high-wear part, bearings are often replaced. This item sold individually. Washers and retainers sold separately.

This is a genuine Makita replacement part, it is sold individually. It is part of the bit holder. Without this Ball the bit would not stay in the holder. It is used in a number of different tools for different reasons. But it is most popular in Cordless Impact Drivers and Corded Screw Drivers. Compatible with the tools listed below. The diameter is 3.5mm.