BTE820K (Type 1) Bostitch Angle Grinder - Overview

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is a replacement part directly sourced from the manufacturer for use in drills, hammers, grinders, sanders, jigsaws, and trimmers made by DeWALT, Porter Cable, Black & Decker, and Bostitch. It connects to the power cord and is made out of metal. This part is extremely small and will need to be replaced if it becomes lost or if it breaks. The terminal is sold individually.

This replacement wrench is a genuine OEM approved part that is used with Dewalt, Black and Decker and Porter Cable agnle grinders. It is used to tighten or remove the outer flange which secures the grinding wheel. Please note this durable metal wrench is sold individually.

This is an authentic manufacturer sourced replacement part, it is specially designed for use with angle grinders. It is the outer flange which is utilized to secure the grinding disk, please note the inner flange is sold separately. This high-quality hardware is made of durable metal and it is sold individually.

This is an original replacement part manufactured for use with angle grinders. The special metal flange sits above the grinding wheel, and provides space between the wheel and guard. This inner flange is sold individually.

This replacement brush set is sourced directly from original equipment manufacturer and it is designed for use with angle grinders. Over time brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. This assembly includes two (2) carbon brushes with lead wires attached. Please...Read more note brush boxes are sold separately. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove screws from the housing • Separate housing to gain access to the brushes • Remove old brushes and secure the new ones in place • Re-assemble and test the tool

This is a genuine replacement part that has been sourced from the original manufacturer to be used with angle grinders from Bostitch and Porter Cable. The switch fits inside the main housing and is used to relay electricity from the power cord to the motor assembly. A screwdriver and needle nose pliers may be needed to instal this item.