BTD141Z Makita Impact Driver - Overview

This is Makitas Lithium-Ion charging system. This charger uses three controls to ensure the best possible charge: Temperature, Voltage, and Current. These controls are monitored by a chip on the battery, and analyzed by a CPU on the charger. This prolongs battery life, and keeps cordless power tools running at peak performance. There is ...Read morea forced air fan on board the charger, keeping batteries cool while re-charging. A 3.0 Ah battery will charge in less than 45 minutes.

This is a genuine Makita replacement part used in compatible impact drivers and impact wrenches. The nylon washer fits between the hammer case and the anvil and is made of plastic. You may need a screwdriver when replacing this item. It may become broken and will need to be replaced. This item is available as an individual replacement part.

This item is a genuine Makita replacement part that has been OEM sourced to ensure quality. The rubber pin is intended to be used with impact drills/drivers, shears, and drywall screwdrivers. The rubber pin is used to provide spacing between the brush card and the housing assembly. This item is sold as a single part.

This is an authentic Makita replacement part that has been sourced from the original manufacturer for use with hammer drills. The metal pan head screw is used with several different types of drills and the application of the screw can vary based on the model of equipment. The screw is sold as an individual replacement part.

This is a Genuine OEM Sourced replacement part designed for Makita Impact Drivers. This part is made out of Metal and it is Sold Individually. This Washer helps to provide seal for the Sleeve. When replacing this part you would need a Screwdriver and Pliers.

It is a genuine high quality item that is sourced from original equipment manufacturer for use with Makita impact drivers. This flat washer is used to provide a tight seal between two connected parts, please make sure to check appropriate diagrams of your tool for correct location and use of this item. One durable metal flat washer is included per order.

This authentic o-ring is supplied by the original equipment manufacturer, it is specially designed for use with Makita impact drivers. Its purpose is to provide an air-tight seal between connected parts, please make sure to refer to appropriate diagrams of your model for the correct location and use of this hardware. Over time the materia...Read morel may wear out and crack eventually requiring a replacement to ensure the peak performance. This high-quality replacement o-ring is made of durable rubber and it is sold indiviudally.

This is a genuine Makita replacement part, it is sold individually. It is part of the bit holder. Without this Ball the bit would not stay in the holder. It is used in a number of different tools for different reasons. But it is most popular in Cordless Impact Drivers and Corded Screw Drivers. Compatible with the tools listed below. The diameter is 3.5mm.