This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
This temperature sensor is for refrigerators.
The temperature sensor senses the temperature inside the refrigerator and sends information to the electronic control.
Unplug the refrigerator and s...
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate...
This hinge is located on the top of the refrigerator.
$83.92
In Stock
Questions And Answers for AZF33X16DW00
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Daniel
November 4, 2023
I set the temp. to cold then appoximently 15min. later I look at it and its on deep freeze . (cold,coldest,deepfreeze) it wont stay where set.
also I have to defrost the coils randomly . I tested defrost coil and it ohms out fine .
For model number AZF33X16DW00
Hello Daniel, thank you for reaching out to PartSelect. You may need to check the control board, part number PS12728628. If it is faulty, then you may need to replace it to fix the issue. We hope that helps!
Freezer will cool but only to just below freezing (21 to 28 degrees) then rises again. Evaporator motor and fan are running fine. Freezer is 4 years old. Door switch seems to be working. Reostat on compressor? I'm confused?
For model number AZF33X16DW00
Hello Tammy, Thank you for the question. We suggest testing the Temperature Sensor, PartSelect Number PS11753994. When testing the resistance of the Thermistor with a multi meter, it should read at around 11,000 ohms at room temperature to be working correctly. We hope this helps!
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again.
An easy job for smaller hands. Removed the two bolts holding the light cover. Removed two electrical connections from the old switch by pinching the retaining clip,removed the switch, snapped in the new one and re-attached the connectors. Your online illustrations helped me to know that the plastic housing for the light switch would only swing down so far and was not intended to be removed. Saved me from breaking that plastic cover's tabs. This home repair saved me more than 5 times the cost of hiring a professional to do it. Very happy homeowner.
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.