This broiler pan and roasting rack set features a two-piece design that allows fat to drain away for cleaner cooking and reduced splatter. Made with a durable, high-heat resistant porcelain finish, it...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bill
November 6, 2025
Tried to change temperature sensor from inside the top oven. Harness connector separated in side the unit. Is there an access panel from the back of the oven?
For model number AOGD2750WW
Hi Bill, thank you for reaching out. Yes, you will have to access the temperature sensor from the back of the oven. The sensor is located on the back panel and is held by a couple of screws and a wiring harness. Disconnect the wiring harness by releasing it from the locking tab. Then, remove the two screws that hold the sensor. Once the crews are out, you can pull out the sensor. Now, feed the new sensor through the same hole in the insulation. Now, put the screws back in and reconnect the wiring harness. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
If your stove work's but your oven won't get hot it is your ignigter the ignighter in proper working condition sends a signal to the gas valve saying let the gas flow its ok. When the ignighter quits working it won't let the gas flow and your oven will not get hot. It is an easy fix. Just pull out all of interior parts the racks and the bottom heat shield the ignighter the white stone looking part that is screwed to the burner with two wires and it really don't matter what way the wires go back one of the wires connects in the back so you will have to pull the oven out. Now you have to clean under it and your done.
Removed oven door and burner guard. Removed screws holding ignitor bracket and small panel beneath oven door. Disconnected ignitor wires behind panel and pulled out ignitor. Removed old ignitor from bracket and inserted new unit. Fed wires back down thru tubing and screwed in bracket. Connected wires and replaced panel. (Note: old ignitor glowed but would not pass enough current to operate gas valve)
.gif "SUPPLEMENTAL INFORMATION Diagram and Parts List for P1132534NWW Amana Wall Oven")
