AF631 Makita Nailer - Overview

This is a genuine OEM replacement part manufactured for use with Makita power tools. The hexagonal nut is used with several different types of equipment and the application of the nut can vary based on the model of the power tool. This hex nut is available as an individual replacement part.

This item is available as an individual replacement part. The hex nut is made out of metal. A wrench might be helpful during the installation of this part. It might break or strip over time and will need replacing. This genuine item is supplied by the original equipment manufacturer for use with blowers, drills, grinders, nailers, rotary hammers, routers, sanders, saws, and trimmers made by Makita.

This authentic OEM sourced item that is specially designed for use with Makita nailers and laminate trimmers. It is an identical replacement for a missing or damaged spring pin that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this comp...Read moreonent. Keep in mind this high-quality item is made of durable metal and is sold individually.

It is a genuine item that is supplied from the original manufacturer for use with Makita nailers. This is the special spring pin that is utilized to secure the Idler 344258-4 which is sold separately. It provides an identical replacement for a missing or a damaged hardware that was installed on a new unit. To ensure the correct applicatio...Read moren of this component please make sure to refer to the owners manual and the appropriate diagram of your model. Note, one durable metal spring pin is included.

This is a genuine OEM sourced replacement part designed for use with a variety of power tools. It is a standard hardware which has multiple applications, please make sure to refer to the appropriate diagrams of your model for the correct location and use of this hardware. Keep in mind this high-quality pan head screw is made of durable metal and is sold individually.

This o-ring is a genuine Makita replacement part, not imitation or overstock. O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure. The most common among power tools are: ...Read more • Extrusion and Nibbling - The O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - The O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - The O-ring has a pitted or cracked surface, and is often flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - The O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching (greater that 5%) causes similar cracking.