9725 (Type 3) Porter Cable Band Saw - Overview

This is an authentic manufacturer sourced replacement brush cap. It is specially designed for Porter Cable band saws and routers. The brush cap is used to secure the carbon brush in the holder. This item is made out of black plastic and it is sold individually. You will need a flat-head screwdriver to install or remove this brush cap.

This genuine item is supplied by the original equipment manufacturer for use with bandsaws made by DeWALT, Porter Cable, and Black & Decker. The stop attaches to the blade guide holder and is made of metal. This part is available as an individual replacement. If this item becomes broken it will need to be replaced and may require a screwdriver, a set of pliers, and a wrench set during the installation.

It is a genuine OEM supplied replacement chain that is specially designed for use with band saws. The purpose of this chain is to rotate the drive pulley, make sure to check appropriate diagram for correct location and use of this part. Over time the chain may wear down or stretch eventually requiring replacement. It is made of high-quality steel and it is sold individually.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

It is a genuine OEM supplied replacement screw which is specially designed for use with power tools. This is one of the screws for the unit, please refer to the appropriate diagrams of your model for the correct location and use of this hardware. Please note it is made of high-quality metal and is sold individually.

The guard attaches to the housing. This is an authentic Porter Cable replacement part that is sourced from the original manufacturer for use with band saws. This item is made of metal and is sold individually. If this part becomes broken it will need to be replaced and may require a screwdriver during the installation.