919176050 Craftsman Compressor - Overview

This is an Genuine OEM replacement part used on Air Compressors. The gauge registers pressure readings and allows you to maintain needed pressure. This Gauge is Sold Individually. You would need a Wrench to secure this Gauge to the Manifold. When replacing this item make sure to unplug the air compressor and bleed out air from the tank.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with air compressors. The hex head screw is used to secure the motor assembly to the bracket on the tank of the compressor. These screws are sold in packs of eight pieces and the packs are sold individually.

This is a genuine replacement part sourced from the original manufacturer for use with air compressors. The special five-pack of nuts are commonly used to fasten the bolt that connects the wheel to the frame. This nut five-pack is available as an individual replacement part, please see model diagram for associative parts.

When using an air compressor, moisture naturally builds up inside the tank as air is compressed. If this water isn’t drained regularly, it can lead to internal rust and damage over time. That’s where the drain valve comes in—it allows you to release the built-up water and keep your tank in good condition. Located at the bottom of the tank...Read more, this valve should be opened after each use to prevent corrosion and extend the life of your compressor. If you tend to leave air in the tank for long periods, water accumulation can be even more significant. This replacement drain valve features a thread size of 18 TPI and is sold individually. Regular maintenance with a working drain valve helps ensure safe and efficient compressor operation.

This is an OEM part sourced directly from the manufacturer. The adapter is designed for use in compressors from DeVilbiss, Black & Decker, Delta, and Porter Cable. This part is made of metal, and may be used to connect the regulator to the tank. You will require a wrench when replacing this part. This item is sold individually.

This is an authentic replacement part, sourced from the original manufacturer for use with generators and air compressors. The shoulder bolt is used with several different types of equipment and the application of the bolt can vary based on the model of the machine. This bolt is available as an individual replacement part.

This is an authentic replacement part sourced directly from the manufacturer. The screw is commonly found in compressors from Porter Cable, Delta, DeVilbiss, Black & Decker, DeWALT, and Bostitch. This part is made of metal, and is generally used to secure the cylinder head to the pump and motor assembly. Please be aware that there are ...Read moredifferent screws used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is available as an individual replacement part.

This is an authentic replacement part sourced directly from the manufacturer. The piston pin plug is commonly found in compressors from Porter Cable, DeVilbiss, and Black & Decker. This part is made of plastic, and is used to hold the piston pin in place within the piston. You may require a flat-head screwdriver to pry the old part free so it can be replaced. This item is sold individually.