919-67007 (Type 0) DeVilbiss Generator - Overview

This is a manufacturer approved isolator that is specially designed for use with electric generators. Its mounted between the motor and the frame to help minimize the vibrations caused by a running engine. One durable rubber isolator with a metal threaded shaft is included per order.

This replacement screw is a genuine OEM sourced item commonly utilized on air compressors and pressure washers. It is a standard hardware which has multiple applications depending on the unit. Please make sure to check diagrams of your model for the correct location and used of this screw. This part is made from durable metal and it is sold individually. You will need a wrench to install or remove this hardware.

This is a genuine manufacturer-sourced replacement screw which is specially produced for use with portable generators and air compressors. Make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. This part is made of high-quality metal and is sold individually.

This is an authentic Porter Cable replacement part that has been sourced from the original manufacturer to be used with air compressors from Porter Cable, DeVilbiss, and Black & Decker. The special clamp is used to secure the connections between fuel lines. This item is sold as an individual replacement part.

This high quality replacement cap is an authentic OEM sourced item that is designed for use with generators. It is designed to keep the fuel in the tank. This fuel cap is made from durable plastic and it is sold individually.

This is an OEM part sourced directly from the manufacturer, sold individually. The grommet is inserted into the fuel tank of the generator to hold the fuel drain cock, which can be shut off to stop the flow of fuel, or opened to allow the fuel to flow to run the generator. No tools are required for installation. Part is compatible with the models listed below.

This is an authentic replacement part sourced directly from the manufacturer. The washer is commonly found in generators from Porter Cable and DeVilbiss. This part is made of metal, and is generally used in securing the fuel tank. You will require a wrench when replacing this item. This product is provided as an individual replacement part.

This genuine OEM fuel tank, also known as the gas tank, in your generator serves as the primary storage for the fuel that powers the engine to produce electricity. Typically positioned on the top of the frame assembly, this gas tank measures 22 inches in length and 18.5 inches in width, with mounting holes positioned 16 inches apart at th...Read moree center and 3 inches apart from each end of the tank. To determine if the fuel tank needs replacement, inspect it for damage, corrosion, rust, or any signs of leaks. To replace the tank, start by removing the securing screws and disconnecting the gas line. Drain the remaining gas into a container. Remove the gas valve from the old tank and take out the tank. Install the new gas valve onto the new tank and securely place the new tank. After reconnecting the gas line and filling the tank with gas, conduct a thorough check to ensure there are no signs of leaks.