8836-0-G2600 Briggs and Stratton Generator - Overview

This brush holder assembly is an authentic OEM replacement part that is specially designed for use on Briggs and Stratton generators. Brushes help to conduct electric current in the motor that powers the unit. This assembly includes one plastic brush holder and two carbon brushes with a lead wires and springs attached. You would need a screwdriver to complete this job.

The battery charge rectifier goes inside the control box. It is an OEM from Briggs & Stratton for use in generators. This part is sold individually and is made of metal. A wrench and a screwdriver may be required to replace this part. It will need to be replaced if it breaks.

This is an authentic Briggs & Stratton replacement part. The bearing is commonly found in generators. This part is made of metal, and is used to allow the rotor assembly to spin freely within the stator. You may require a wrench when replacing this part. This item is sold individually.

This is a genuine part that is supplied by the original manufacturer for use with Briggs and Stratton and Toro engines. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. This part is made of nylon rope and is sold individ...Read moreually. To install the rope you will need a screw driver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.