7761A-77 Norge Dryer - Overview

If your clothes are taking longer to dry or coming out with lint, it might be time to replace your dryer’s lint filter. This easy-to-install part catches lint and debris during each cycle, helping your dryer work better and keeping your clothes cleaner. Just slide out the old filter and pop in the new one—it’s a quick fix that can make a big difference in drying performance and safety.

This kit comes in two pieces: the catch and the clip.

Included in this rear drum support roller kit are 4 screws, 1 spacers, 2 washers, 2 retaining rings, 2 rear rollers, and 2 cylinder support shafts. *** Note: Per manufacturer this kit has been updated now to have one spacer that is the thickness of 2 spacers. To get these parts separately, please search by model#.

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This screw is sold individually.

This screw is sold individually.

This blower wheel is suitable for some clothes dryers of the 10 and earlier series. Manufactured to fit a 1/2 inch motor shaft, this blower wheel is 3-1/8 inches deep. The diameter of the wheel is 7-1/8 inches, and the spring clamp is not included.

If this part appears to be too wide for your particular appliance, per the manufacturer, all you have to do is pull it apart.

Depending upon your model, this seal can be used on either the front or rear drum. The hi-temp adhesive is sold separately.

This kit includes 2 glides (left and right), 2 pads with adhesive backing and 1 support brace.

Pad has adhesive backing.

L146-25F 240 Volt internal heater. This thermostat helps to regulate the dryer's internal temperature.