7748A Norge Dryer - Overview

This dryer drum belt has four ridges, three grooves and is 1/4" wide.

If your clothes are taking longer to dry or coming out with lint, it might be time to replace your dryer’s lint filter. This easy-to-install part catches lint and debris during each cycle, helping your dryer work better and keeping your clothes cleaner. Just slide out the old filter and pop in the new one—it’s a quick fix that can make a big difference in drying performance and safety.

This kit comes in two pieces: the catch and the clip.

This 240-volt, 4750-watt heating element kit is designed to restore proper heat output in select dryer models. It generates the heat necessary to dry clothing efficiently during each cycle. If your dryer is taking longer than usual to dry clothes or isn’t producing heat at all, the heating element may need replacement. Installation requir...Read morees disconnecting the power and using basic tools such as a putty knife, quarter-inch nut driver, and needle nose pliers. This kit is sold individually and does not include additional accessories.

Included in this rear drum support roller kit are 4 screws, 1 spacers, 2 washers, 2 retaining rings, 2 rear rollers, and 2 cylinder support shafts. *** Note: Per manufacturer this kit has been updated now to have one spacer that is the thickness of 2 spacers. To get these parts separately, please search by model#.

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This screw is sold individually.

This part is the replacement thermal fuse for your dryer. It measures a little more than an inch wide, and about ¾ inch long. The thermal fuse is a safety device that shuts off the burner in a gas dryer, or the motor in an electric dryer when the dryer overheats. If your dryer will not start, or if it is not producing any heat, you may ne...Read moreed to replace the thermal fuse. Be sure to disconnect power to the dryer before you begin this repair. This part is sold individually and is an authentic OEM part sourced from the manufacturer.

This screw is sold individually.

This blower wheel is suitable for some clothes dryers of the 10 and earlier series. Manufactured to fit a 1/2 inch motor shaft, this blower wheel is 3-1/8 inches deep. The diameter of the wheel is 7-1/8 inches, and the spring clamp is not included.

If this part appears to be too wide for your particular appliance, per the manufacturer, all you have to do is pull it apart.

This screw is sold individually.