726 (Type 3) Porter Cable Band Saw - Overview

Included in part number 864707

This is an authentic manufacturer sourced replacement brush cap. It is specially designed for Porter Cable band saws and routers. The brush cap is used to secure the carbon brush in the holder. This item is made out of black plastic and it is sold individually. You will need a flat-head screwdriver to install or remove this brush cap.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

It is a genuine OEM supplied replacement screw which is specially designed for use with power tools. This is one of the screws for the unit, please refer to the appropriate diagrams of your model for the correct location and use of this hardware. Please note it is made of high-quality metal and is sold individually.

The guard attaches to the housing. This is an authentic Porter Cable replacement part that is sourced from the original manufacturer for use with band saws. This item is made of metal and is sold individually. If this part becomes broken it will need to be replaced and may require a screwdriver during the installation.

This is a genuine OEM sourced high quality carbon brush, not an aftermarket imitation. It is specially designed for Porter Cable band saws. This item includes (1) carbon brush with a spring and a lead wire attached. Please not the brush holder and the brush cap are both sold separately. It is advised to replace both brushes at the same ty...Read morepe. Replacing this carbon brush is a very easy task that should only require a flat-head screwdriver. • Make sure the tool is unplugged first • Remove the brush cap from the housing • Take out the old brush • Secure the new brush in the holder • Reattach the brush cap and test the tool

This genuine manufacturer-approved replacement switch is specially designed for use with Porter Cable power tools. It is the part of the tool handling on/off and variable speed operations. Over time due to mechanical or electrical issue the switch may begin to fail eventually requiring replacement. Please note this durable plastic switch is sold individually.