690LR Porter Cable Router - Overview

This Porter-Cable router sub base is an OEM replacement part. It is found on 690 series routers and allows a router to glide smoothly on the routing surface. This sub base comes complete with the plastic sub base and three countersunk screws for installation.

This is a genuine replacement part sourced from the original manufacturer for use with routers. The special straight edge guide is used to guide the router along the material being cut. This straight edge guide is available as an individual replacement part, please see model diagram for associative parts.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This replacement collet is an authentic manufacturer-sourced component which is specially designed for use with Porter Cable and Black and Decker routers. Its purpose is to provide a tight grip for securing a router bit. It is a high-quality part which is made of durable metal and it is sold individually, please note the collet nut is sol...Read mored separately. Keep in mind that this collet is for using bits with 3/8" arbors only.

This is the o-ring that helps to create an air-tight seal between the housing and the brush cap. Over time it may deteriorate and crack eventually requiring replacement to maintain strong seal. It is a genuine replacement part that is supplied directly from original equipment manufacturer for use with Porter Cable and Black and Decker pow...Read moreer tools. Please note this part is made from durable rubber material and it is sold individually.

OD 5 3/4" ID 2 1/2"

This is an Authentic Manufacturer Approved replacement part used on Routers. This part provides a firm grip for holding a bit in a tool. It is made out of Metal and is Sold Individually. This Collet is for using bits with 1/2" arbors only. Includes the 1/2" Collet and a Collet Nut. Due to prolonged, heavy use a Collet may need to be repl...Read moreaced eventually. To replace this Collet you would need to use a Wrench. • First you would need to remove the Collet Nut • Once the Nut is removed you can remove the old Collet • Place a new one in place • Tighten the Collet Nut back in place and your unit is ready to use 1/2" Bits

This is a Genuine Manufacturer Approved replacement part used on some Routers. This part provides the firm grip for holding a bit in a tool. This Collet is for using bits with 1/4" arbors. Due to prolonged, heavy use a collet may need to be replaced. Collet Nut is included in this Assembly.

This item has been sourced from the original manufacturer and is intended to be used with routers from Porter Cable and Black & Decker. The fan attaches to the motor's armature assembly. This item is used to move air over the motor to prevent the motor from overloading. This item is sold as an individual replacement part.