690LR (Type 2) Porter Cable Router - Overview

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is the o-ring that helps to create an air-tight seal between the housing and the brush cap. Over time it may deteriorate and crack eventually requiring replacement to maintain strong seal. It is a genuine replacement part that is supplied directly from original equipment manufacturer for use with Porter Cable and Black and Decker pow...Read moreer tools. Please note this part is made from durable rubber material and it is sold individually.

Genuine OEM replacement part, this item is sold individually. This Wrench is used to remove and install the collet assemblies on the tools listed below. Two of these wrenches are needed to accomplish this. • One to hold the collet nut. • And one to hold the collet chuck.

This is an OEM part sourced directly from the manufacturer. The terminal is commonly found in routers from Porter Cable, Black & Decker, and DeWALT. This part is made of metal and plastic, and is used to form an electrical connection between the power cord and the machine. You may require a screwdriver and pliers when replacing this item. The terminal is available as an individual replacement part.

This is an Authentic Manufacturer Approved replacement part used on Routers. This part provides a firm grip for holding a bit in a tool. It is made out of Metal and is Sold Individually. This Collet is for using bits with 1/2" arbors only. Includes the 1/2" Collet and a Collet Nut. Due to prolonged, heavy use a Collet may need to be repl...Read moreaced eventually. To replace this Collet you would need to use a Wrench. • First you would need to remove the Collet Nut • Once the Nut is removed you can remove the old Collet • Place a new one in place • Tighten the Collet Nut back in place and your unit is ready to use 1/2" Bits

This is a Genuine Manufacturer Approved replacement part used on some Routers. This part provides the firm grip for holding a bit in a tool. This Collet is for using bits with 1/4" arbors. Due to prolonged, heavy use a collet may need to be replaced. Collet Nut is included in this Assembly.

This item has been sourced from the original manufacturer and is intended to be used with routers from Porter Cable and Black & Decker. The fan attaches to the motor's armature assembly. This item is used to move air over the motor to prevent the motor from overloading. This item is sold as an individual replacement part.