662 (Type 1) Porter Cable Sander Polisher - Overview

It is a genuine OEM supplied replacement screw which is specially designed for use with power tools. This is one of the screws for the unit, please refer to the appropriate diagrams of your model for the correct location and use of this hardware. Please note it is made of high-quality metal and is sold individually.

This is a needle bearing that is open on both sides. This genuine Porter Cable replacement part is sold individually. • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduc...Read morees wear on the tool, allowing it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

It is an authentic manufacturer-supplied washer which is made for use with Black and Decker, Porter Cable and DeWALT power tools. This is one of the insulators for the carbon brush. It is an identical replacement for a missing or a damaged hardware that was installed on a new tool. Check the parts diagram for your model to ensure the corr...Read moreect repair procedure. Note, this high-quality brush insulator is made of durable material and is sold as an individual item.

This is an authentic replacement part, sourced from the original manufacturer for use with electric power tools. The special brush holder is used to secure the carbon brushes. This brush holder is available as an individual replacement part, please note two brush holders are required.

Genuine Porter Cable replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can rest...Read moreore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Genuine Porter Cable replacement part, this item is sold individually. This screw is used in various parts of the tools shown below. It can found in each of the tools securing different internal parts of these tools. It is a Torx T-25 screw.