This part is a replacement wheel assembly for your lower dishrack. The wheels on the dishrack allow it to roll in and out of the dishwasher efficiently. If one of your wheels is broken or warped, you ...
$31.46
In Stock
Order within the next 7 hrs and your part ships today!
Order within the next 7 hrs and your part ships today!
Questions And Answers for 58715412100A
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Orhan
December 9, 2019
Our washer is puchased mach.13.2013. Yesterday when washer starded just when loading water in key board er flashing and discharging water out to drain. It did not reset to go. What is the problem? Would you please get back to me? Thanks very much.
For model number 58715412100A
Hello Orhan, thank you for your question. We would recommend shutting the power off to the unit and trying to reset it. When the power is restored and the error code is still there we would recommend checking the following parts. PartSelect Number: PS2379446 Thermostat, Heating Element PartSelect Number: PS2379443 SWITCH PartSelect Number: PS2379451 and PC BOARD ASSEMBLY PartSelect Number: PS3419924. I hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Gaetan
December 28, 2022
My rinse agent dispensor always empty out what could be the cause
For model number 58715412100A
Hello Gaetan, thank you for contacting us. The most probable cause of the issue is a faulty detergent dispenser, part number PS11770680. Customer service is available 7 days a week if you require assistance placing an order. Thanks again for reaching out!
Disconnect from power Unscrewed 4 phillips screws from top of outer door. Unscrewed 2 screws each siide of door. Lower outer door section drops away. Note wiring sequence on dispenser, then disconnect wires. Unscrew 6 screws on dispenser and lift dispenser out.
Place new dispenser in place (note orientation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw. Reconnect wires to dispenser correctly. Slide lower outer door over tabs and secure with the 4 side screws. Ensure lower door is up under control panel and secure with the 4 top screws.
Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
replacing dishrack was simply removing old and sliding new onto track. however, removing and reinstalling water dispenser blade mounted on bottom of existing rack to new rack required much more time and effort .I needed to use flat screwdriver to pry plastic clamps apart and then a pair of channel locks to release assembly from original rack. It took some effort to finally accomplish . I believe all models that use this replacement rack would have this same issue with the dispenser blade and instructions for re-installation should accompany the new rack or better yet, new blade should be included on rack for those not familiar with using tools.