58714013400 Kenmore Dishwasher - Overview

This gasket goes on the bottom of the dishwasher door to create a tight seal between the tub and the outer edge of the door. If the gasket is cracked or broken, it will need to be replaced to keep water from leaking out on to the floor. The gasket is approximately 23” long and is a genuine OEM part. It is recommended that once you have in...Read morestalled the gasket to leave the door closed for a few hours to make sure the gasket is properly sealed.

The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, or you notice that your dishwasher is not cleaning dishes properly, you may need to replace the rack wheel. The single rack roller kit is mad...Read moree of white plastic, and clips to the dishwasher rack with the included axle/clip. Many of our customers have described this repair as easy, and you will not require any tools to complete it. Lower rack roller and bracket assembly, grey. Wheel has been updated. If wheel pictured is not like old one, you may need to replace all wheels.

This lower spray arm assembly is a vital component in your dishwasher, responsible for distributing water and detergent throughout the tub during the wash cycle. Its rotating motion ensures thorough cleaning by spraying water in multiple directions. Typically mounted to a hub at the bottom of the dishwasher, a damaged spray arm may cause ...Read moreknocking sounds, restricted rotation, or poor cleaning results. Replacing it helps eliminate food residue and unpleasant odors. Installation is simple—just lift the center of the old arm to release it, and snap the new one into place. This OEM part is sold individually.

Sold Individually.

The drain hose connects to the pump located below the lower spray arm. It aids in proper dishwasher drainage. Size: 7.5 feet long

Sold individually. Grey in color.

This linkage attaches to the door spring.

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

The pump ejects the water from the dishwasher.

The tubing carries water from the water inlet valve to the tub.

If your dishwasher’s top rack is worn or broken, this replacement rack is a great fix. Made to fit select Frigidaire models, it’s sturdy, easy to install, and helps your dishes stay in place for a better clean. The grey finish blends in nicely with most interiors. Just double-check your model number to make sure it’s the right match.

The manufacturer has redesigned this part and it may appear different than the original, but will have the same functionality. This part releases the detergent and rinse aid into the dishwasher.