580752000 Craftsman Pressure Washer - Overview

This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is made of durable metal and is sold individually.

This is an authentic OEM part for use with Craftsman Pressure Washers. The wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reasons for replacing the spray wand are when it is worn-out or is leaking. This part is sold individually. The tool that you will need to replace the wand is a 5/8 inch wrench. Shut the pressure washer off before installing the wand.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.

This replacement hose is a genuine OEM sourced item that specially produced for use with Craftsman pressure washers. This 25 ft. high-pressure hose is made of durable rubber with metal fittings and it is sold individually. It can be used on pumps that produce up to 2600 PSI. Over time the material may deteriorate or get damaged eventually requiring replacement to maintain a working unit.

It is a genuine OEM sourced item that is designed for Briggs and Stratton, Snapper and Troy-Built pressure washers. The manifold housing is an important component that attaches to the pump head. It houses the unloader valve, the check valves, the outlet tube and the chemical injection assembly. If the manifold housing is worn or damaged i...Read moret can cause water leaks and it should be replaced to ensure the equipment is functioning properly. To determine the exact location and the correct installation of this manifold housing, refer to the appropriate diagrams of your model. You will need a screwdriver and a wrench set to perform this repair. This high-quality manifold housing is made of durable metal and is sold as an individual component.

Part 706385 Front Facing Pump and 706384 Rear Facing Pump Kits are the replacement for this pump.

It is an authentic manufacturer-supplied check valves kit which is designed for use with Briggs and Stratton, Snapper and Troy-Bilt pressure washers. The check valves are important components that attach to the pump head to help maintain safe working water pressure in the pump. Unfortunately, over time they may wear out or get damaged eve...Read morentually requiring replacements. It is a high-quality kit which includes six check valve, the O-rings, and the hardware to secure them. Make sure to refer to the appropriate diagrams and the owner's manual for your model to ensure the correct replacement procedure. An Allen wrench set will be needed to take apart and reassemble the pump housing when replacing these components.